-----Original Message-----
From: Eric B. [mailto:[email protected]]
Sent: Friday, January 26, 2007 7:56 PM
To: Bahn William L Civ USAFA/DFCS
Cc: [email protected]
Subject: Re: [Discuss-gnuradio] B input on BasicRX not workingOn Fri, Jan 26, 2007 at 06:42:46PM -0700, Bahn William L Civ
USAFA/DFCS
wrote:If I understand you correctly, you are trying to receive a signal
sent
in to the “RX-B” input of a BasicRX board, as opposed to the “RXB”
slot
of the USRP (gotta love the completely clear and unambiguous
labeling).I share your sentiment about the labeling.
If that is the case, then to get input from the B side you need to
use
A:1 as the source (if the BasicRX is plugged in to RXA) and B:1 if
it is
plugged in to RXB.Where, might you ask, is this and other things like it documented?
As
near as I can tell, it isn’t. On about the third time that I asked
the
same question someone on this board finally let me in on the secret.Perhaps someone on the list (you?) would like to start by documenting
the typical command line options somewhere in the wiki?
We’ve been discussing something very much like this occasionally over
the past couple weeks - in particular, how we could contribute useful
information and applications to the community. At this point, my main
concern is that I know so little that I am almost certain to give out
incomplete information. Or, much worse, flat out wrong information which
would be worse than no information at all.
Having said that, here is my initial contribution.
http://gnuradio.org/trac/wiki/ApplicationProgramInterfaces
I’m not terribly fond of the layout, but don’t know how much control I
can actually exercise over it (or how much effort would be involved)