Hi Everyone,
Does anyone have a suggestion for an off the shelf low frequency
amplifier to use with the USRP? I have a USRP2 with a LFTX board and I
run the RF output to a Bias T attached to an LED driver (I’m using the
system as a Visual Light Commmunication setup). I noticed that the
Ettus FAQ suggests using a simple connectorized amplifier, but the
minimum operating frequency for anything I’ve found is around 10MHz,
and the max frequency my system can operate at is 5MHz (bandwidth
limitations of the LED).
Any suggestions would be greatly appreciated,
Michael R.
Graduate Research Assistant
Smart Lighting Engineering Research Center
Boston University
[email protected]